EuNA

■Overview "EuNA" is a trend-following scalping EA that operates on EURUSD and M5. It is a spin-off EA of the previous work, "EuNA," with the same base logic and increased entry frequency and profitability. It contains two logic systems, which enter the market during a long-term trend with a short-term reverse trend. Each logic can be turned On/Off and most of the parameters can be set individually. By checking for waves and entering at a small SL value, and by using the Eva Mode, low drawdowns can be achieved. Note: With the default settings, it can only operate with brokers that have a zero stop level. Announcement 2020.5 v2.0g upgrade has been made. The changes are as follows * Parameters have been adjusted. * SL values for each logic have been changed: SL_KR=100, SL_SNA=80. * With the increase in SL, we have added an internal withdrawal logic. The new withdrawal logic is always On. * Slippage Slippage is now set on a per-point basis. Features ・High frequency, high winning rate scalping EA that can be operated on the Eurodollar (EURUSD) and is dedicated for 5-minute trading. Two logics operate independently. Each logic can be set On/Off and most parameters can be set individually. There is also the possibility of double trades. Simple logic using MACD, moving averages, RSI, ADX, etc., to enter the market in a short-term reverse direction during a long-term trend. The trailing stop is used to make a profit above the fixed pips. By entering at a small SL price after confirming the wave motion, we have achieved low drawdowns. By using the Eva Mode, we close at the best position even in the event of a losing position. We do not use any "pick-and-pin" or "martingale" strategy. We do not enter at unfavorable time frames. Entry control time can be set on Fridays (weekend). (By default, no entry control is performed.) Position closure can be set for Friday weekends. (By default, entry is not restricted.) ・The default setting is to close a position on Friday. The default setting allows only brokers with a zero stop level to operate. If you wish to use a broker with a non-zero stop level, you can turn off the trailing stop, but this will result in a slight drop in performance. The Daily Filter and Economic Indicator Filter allow you to set the time when you want to limit entry. Back Test Result ・This is the result of back test since May 2003 by TDS (Tick Data Suite). (Fixed at 0.1 lot. Variable spread is used. Zero commission. Dollar basis.) Despite the large number of trades, the winning rate is over 80%. There have been no negative years on a yearly basis, but on a monthly basis, there have been two consecutive 3-month losing streaks at most. The following is the result of analysis by QuantAnalyzer. ■ Forward Testing Real forward testing is available. Please refer to Real Trade on the right or the author's blog. https://rmtfxbotter.hatenablog.com/ ■Limitations * Please note that the results of this EA are based on the assumption that the time setting is GMT+2/+3 brokers. The default setting is a narrow spread. Please note that there is a possibility that entries may not be made with brokers with wide spreads, in which case you can use a wider spread setting, but the performance will change. With the default settings, you can only operate with brokers that have a zero stop level. If you wish to use a broker with a non-zero stop level, you can turn off the trailing stop and change the TP (e.g., KR: 8.5, SNA: 11), but the performance will be slightly lower. EA Settings * If you want to use the default settings, right click on MT4 Quote Display>EURUSD, select Specifications, and make sure the stop level is zero. * Set this EA on EURUSD, M5 (5-minute) chart. * Please set the magic number so that it does not overlap with other EAs. ■Parameter Description Below is the description of the parameters. Note_11 Magic Number for Logic KR, Logic Control MAGIC_KR = 20190711 ; For Magic Number, Logic KR Duplicates the numbers of other EAs and Logic SNAs. * Note_11 Magic number and logic control of Logic KR MAGIC_KR = 20190711 ; for Magic number and Logic KR Please be careful not to duplicate other EA and Logic SNA numbers Logic_KR = true ; On/Off of Logic KR. true is On * Note_12 Order related settings for Logic KR Lot_KR = 0.1 ; Lot of Logic KR TP_KR = 150 ; TP of Logic KR (in pips) SL_KR = 100 ; Stop Loss of Logic KR (in pips) SlippagePoint_KR = 20 ; Slippage of Logic KR Slippage Slippage (in points) MaxSpreadPoint_KR = 14 ; Spread (in points) of logic KR * Note_13 Trailing Stop of logic KR Trail_KR = true ; Trailing Stop On/Off of logic KR. True is On TL_StartPips_KR = 8.5 ; Trailing stop start pips in pips for logic KR TL_OffSet_KR = 0.3 ; Trailing stop offset pips in pips for logic KR TL_interval_KR = 5 ; trailing stop interval in seconds for logic KR * Note_14 withdrawal mode for logic KR Evacuate_Mode_KR = true ; withdrawal mode On/Off for logic KR. true is On gEvaStartPips_KR =-20 ; withdrawal start for logic KR pips (in pips) gEvaStartHour_KR = 4 ; Elapsed time for the start of withdrawal of the logic KR (in hours) * Note_21 Magic number of the logic SNA, logic control MAGIC_SNA = 20190712 ; Magic number, for logic SNA Other EA, logic Logic_SNA = true ; On/Off for logic SNA. true is On * Note_22 Order-related settings for logic SNA Lot_SNA = 0.1 ; Lot for logic SNA TP_SNA = 200 ; TP for logic SNA ( SL_SNA = 80 ; Stop loss of logic SNA (in pips) SlippagePoint_SNA = 20 ; Slippage slippage of logic SNA (in points) MaxSpreadPoint_SNA = 18 ; Spread of logic SNA (in points) Trail_SNA = true ; On/Off. true is On TL_StartPips_SNA = 11 ; Start pips of the trailing stop of the logic SNA (in pips) TL_OffSet_SNA = 0.1 ; Logic SNA trailing stop offset pips in pips TL_interval_SNA = 3 ; Logic SNA trailing stop interval in seconds * Note_24 Logic SNA withdrawal mode Evacuate_Mode_SNA = true ; On/Off, where true is On gEvaStartPips_SNA = -11 ; withdrawal start pips for logic SNA (in pips) gEvaStartHour_SNA = 1 ; withdrawal start elapsed time for logic SNA (in hours) * Note_30 Compound interest function MoneyManagement = false; true (compound interest), false (fixed lot) MM_Mode = Balance; selects the source for calculating the number of lots: Balance (account balance), FreeMargin (excess margin) input_RiskPct = 1; when calculating the number of lots, the number of lots is calculated based on the number of lots at SL against the source. The percentage of loss at SL is calculated for the underlying. * Note_51 Weekend Entry Suppression Setting gNoTradeFrom = 25 ; Entry suppression start time (server time) gNoTradeUntil= 25 ; Entry suppression end time (server time) * Note_52 Weekend Close Time Setting Weekend_Close = 25 ; Close all positions at the specified Friday If a number greater than 24 is specified, the position will not be closed and the week will be extended. Note_53 Weekend Entry Inhibit gYearEndFrom = 25 ; December date; after this date, entries during the year will be inhibited Note_54 Daily Entry Inhibit gYearEndFrom = 25 ; daily entries at the specified time will be inhibited. d1NoTradeFrom = "25:00"; Entry suppression start time (server time) d1NoTradeUntil= "25:59"; Entry suppression end time (server time) d2NoTradeFrom = "25:00"; Entry suppression start time (server time) d2NoTradeUntil= "25:59"; Entry suppression end time (server time) Note_550 Suppression setting at the time of index release Suppresses entries at the specified time, including the day of the week. w1NoTradeFrom = "6:00:00"; entry suppression start time (server time) w1NoTradeUntil= "6:00:59"; entry suppression end time (server time) w2NoTradeFrom = "6:00:00"; entry suppression start w2NoTradeUntil= "6:00:59"; Entry suppression end time (server time) Comment_1 Comment Settings Comments = "EuNA v2.0g"; Additional logic name (KR, or SNA) will be added ■ Author's Blog EA I am writing about the operation of the EA. https://rmtfxbotter.hatenablog.com/ ■Updated information ・v1.00g Initial version ・v1.1g Fixed a case where the weekend close was not triggered. The parameters have been adjusted. * SL values for each logic were changed: SL_KR=100, SL_SNA=80. * With the increase in SL, we have added a withdrawal logic using internal logic. The new withdrawal logic is always On. * Slippage Slippage is now set on a per point basis.