"ATS-12 RSI" Last week's result ～2024/10/19
Last week's results announcement!
(Trading with 1,000,000 yen margin / 0.3 Lots)
Aggregation period: 2024/10/14 to 2024/10/19
In one week, 62,374 yen of profit was made!
Even with a small lot of “0.3Lots,” such substantial profits are possible!
The week before last’s plus 76,852 yen continuing, we have achieved good results!
Here we introduce actual trading results using the ‘ATS-12 RSI’.
There are several trading methods using ‘ATS-12 RSI’, and we will also explain at what timing to acquire and close positions when using this system.
We will also publish what settings were adopted.
Last week's settings
[October 14]
[Settings image 1]
[Settings image 2]
[Settings image 3]
As shown in the above three charts, we set up ‘ATS-12 RSI’ and traded with the above settings.
※ An optimization data automatic extraction search engine is also included, so you can easily find settings that fit current market conditions!
On [October 16], we changed the optimization data!
[Settings image 1]
[Settings image 2]
[Settings image 3]
From mid-week, we changed the settings and trading patterns.
※ You can update the optimization data at any time. Of course, you can use the automatic extraction search engine again to easily find settings that suit the current market!
Last week's results!
[Trading history image]
[Trading history image / enlarged]
The results are impressive!
In one week, 62,374 yen of profit was made!
This time, we started trading with the pattern introduced later in “2. Scalping Trade (Mid-Level)” and from October 16 we tried trading with “1. One-shot Trade (Beginner)”!
The three trading methods are introduced at the end of this article.
Results prior to that!
(Trading with 1,000,000 yen margin / 0.3 lots)
Aggregation period: 2024/10/07 to 2024/10/12
Settings at that time here
＋76,852 yen
[Trading history image]
Three trading methods
Acquisition is at the first signal, and closing is at the scalping-mode closing point. A high-win-rate and solid trade is possible.
※ We recommend this method until you learn the tips and start winning.
This method trades only once between the start flag and end flag. The points you can gain are modest, but it is the most winning and robust among the three methods. First, set the parameter “ScalMode_Flag” to ON “true.” The chart will display acquisition/closing points suitable for scalping.
① The first flag is the acquisition point.
② Then, close at the scalping closing point.
③ If an end flag appears while holding a position, forcibly close.
At first, after acquiring point ① is obtained, when point ② is displayed, it is prudent to close at a positive stage.
As you get used to it, try aiming for the second and third points and subsequent scalping closing points.
■ About settings: The numbers on the score panel don’t need to be as high as the other two methods.
This scalping method trades several times between the start flag and end flag. Depending on the case, it can yield the most points among the three methods.
First, set the parameter “ScalMode_Flag” to ON “true.” Scalping acquisition/closing points will be displayed.
① When the scalping acquisition point is displayed, acquire the position.
② Close the position at the closing point.
③ Trade a few times until the end flag is displayed.
④ If an end flag appears while holding a position, forcibly close and wait for the next opportunity.
※ There are two major approaches to acquisitions within this method.
One: after acquiring one position, simply wait for the closing point.
Another: with very small lots, add positions at each acquisition point and close all at the closing point, repeating.
Both approaches can yield results. Until you get used to it, start with small lots and find a method that suits you; that exploration is part of the fun.
Once you become accustomed to this method and can generate profits, try applying higher-level settings using the related system. I believe you can achieve even greater results.
■ About settings: This method benefits from high-level settings.
Using the automatic detector “ATS-12 RSI AutoSearch” and the one-click acquisition “ATS-12 RSI 1Click” will help you achieve results efficiently.
【Trading Method 3】 Basic swing and day trading
This method acquires at the start flag and closes at the end flag in a simple approach.
Set the parameter “ScalMode_Flag” to OFF “false,” and hide the scalping signs. ① Acquire position at the start flag.
② Close at the end flag.
Acquiring and closing is very straightforward, but the settings are actually very important.
Trading according to signals yields results equal to the values on the score panel.
Also, per-trade profit and loss is the largest with this method.
In other words, this method is simple yet requires the highest-level settings.
■ About settings: This method requires the highest-level settings. We recommend having the included “ATS-12 RSI AutoSearch.”
This post is the section of the table below.■portion.
Using RSI to trade in line with the current trend, we would like to introduce some of the data extracted from ‘ATS’.
We will explain how to read and use this data later at the end!
(Trading with 1,000,000 yen margin / 0.3 Lots)
Aggregation period: 2024/10/14 to 2024/10/19
In one week, 62,374 yen of profit was made!
Even with a small lot of “0.3Lots,” such substantial profits are possible!
The week before last’s plus 76,852 yen continuing, we have achieved good results!
Here we introduce actual trading results using the ‘ATS-12 RSI’.
There are several trading methods using ‘ATS-12 RSI’, and we will also explain at what timing to acquire and close positions when using this system.
We will also publish what settings were adopted.
Last week's settings
[October 14]
[Settings image 1]
[Settings image 2]
[Settings image 3]
As shown in the above three charts, we set up ‘ATS-12 RSI’ and traded with the above settings.
※ An optimization data automatic extraction search engine is also included, so you can easily find settings that fit current market conditions!
On [October 16], we changed the optimization data!
[Settings image 1]
[Settings image 2]
[Settings image 3]
From mid-week, we changed the settings and trading patterns.
※ You can update the optimization data at any time. Of course, you can use the automatic extraction search engine again to easily find settings that suit the current market!
Last week's results!
[Trading history image]
[Trading history image / enlarged]
The results are impressive!
In one week, 62,374 yen of profit was made!
This time, we started trading with the pattern introduced later in “2. Scalping Trade (Mid-Level)” and from October 16 we tried trading with “1. One-shot Trade (Beginner)”!
The three trading methods are introduced at the end of this article.
Results prior to that!
(Trading with 1,000,000 yen margin / 0.3 lots)
Aggregation period: 2024/10/07 to 2024/10/12
Settings at that time here
＋76,852 yen
[Trading history image]
Three trading methods
1. Beginner – One-shot Trade
【Trading Method 1】 High-win-rate, solid day-trading mode too!Acquisition is at the first signal, and closing is at the scalping-mode closing point. A high-win-rate and solid trade is possible.
※ We recommend this method until you learn the tips and start winning.
This method trades only once between the start flag and end flag. The points you can gain are modest, but it is the most winning and robust among the three methods. First, set the parameter “ScalMode_Flag” to ON “true.” The chart will display acquisition/closing points suitable for scalping.
① The first flag is the acquisition point.
② Then, close at the scalping closing point.
③ If an end flag appears while holding a position, forcibly close.
At first, after acquiring point ① is obtained, when point ② is displayed, it is prudent to close at a positive stage.
As you get used to it, try aiming for the second and third points and subsequent scalping closing points.
■ About settings: The numbers on the score panel don’t need to be as high as the other two methods.
2. Intermediate – Scalping Trade
【Trading Method 2】 Scalping mode!
This scalping method trades several times between the start flag and end flag. Depending on the case, it can yield the most points among the three methods.
First, set the parameter “ScalMode_Flag” to ON “true.” Scalping acquisition/closing points will be displayed.
① When the scalping acquisition point is displayed, acquire the position.
② Close the position at the closing point.
③ Trade a few times until the end flag is displayed.
④ If an end flag appears while holding a position, forcibly close and wait for the next opportunity.
※ There are two major approaches to acquisitions within this method.
One: after acquiring one position, simply wait for the closing point.
Another: with very small lots, add positions at each acquisition point and close all at the closing point, repeating.
Both approaches can yield results. Until you get used to it, start with small lots and find a method that suits you; that exploration is part of the fun.
Once you become accustomed to this method and can generate profits, try applying higher-level settings using the related system. I believe you can achieve even greater results.
■ About settings: This method benefits from high-level settings.
Using the automatic detector “ATS-12 RSI AutoSearch” and the one-click acquisition “ATS-12 RSI 1Click” will help you achieve results efficiently.
3. Intermediate/Advanced – Swing & Day Trade
【Trading Method 3】 Basic swing and day trading
This method acquires at the start flag and closes at the end flag in a simple approach.
Set the parameter “ScalMode_Flag” to OFF “false,” and hide the scalping signs. ① Acquire position at the start flag.
② Close at the end flag.
Acquiring and closing is very straightforward, but the settings are actually very important.
Trading according to signals yields results equal to the values on the score panel.
Also, per-trade profit and loss is the largest with this method.
In other words, this method is simple yet requires the highest-level settings.
■ About settings: This method requires the highest-level settings. We recommend having the included “ATS-12 RSI AutoSearch.”
This post is the section of the table below.■portion.
Using RSI to trade in line with the current trend, we would like to introduce some of the data extracted from ‘ATS’.
We will explain how to read and use this data later at the end!
(Paid version) |
(All 8 sessions) (Free) |
(Free) |
(Free) |
||
| ATS-12 RSI | 70% OFF [From here] |
Free 공개 now! [From here] |
公開中！ [From here] |
|
|
| ATS-13 RCI | 75% OFF [From here] |
Start decision! |
公開中！ [From here] |
[From here] |
|
| ATS-11 Ma | 80% OFF [From here] |
Start planned! |
Please! [From here] |
Continuing! [From here] |
× ![]()
