[October 23, 2026] Ten to Chi Series: 3 Types × Chart Verification (Europon)
What we will introduce here is the chart verification of EURGBP (EURGBP). We will explain based on a discretionary trading method that uses the TenToChi (TentoChi) series. The entry timeframe is 15 minutes, and for environment recognition we use the 4-hour and daily charts.
※This verification article is described at the bottom of the page.
What is the Ten to Chi Indicator?
・In this article,“Ten to Chi Indicator” is used“Ten to Chi Day Swing” is examined and discussed. Furthermore, the usage method of “Prime Combo Signal” is also explained.
For the basic trading method of the Ten to Chi Indicator, please refer to articles before August 2024. Please refer to.
This is the full set that includes everything necessary to build the two systems I actually operate—the Ten to Chi Day Swing and the Prime Combo Signal—without any compromise. It is not a haphazard collection of indicators. It is a complete single-strategy set. This is my entire approach to trading.
About the Terminology in the Ten to Chi Series
EURGBP／ 15-minute chart +4-hour chart + daily chart Backtest
※The yellow circles mark important points.
※ Clicking the chart will enlarge it.
Important points
Summary
As usual, after confirming the downward bias on the daily and 4-hour charts, we aim to sell on rallies by using the 15-minute line-touch entry pattern.
First of all, the daily oscillator is what to focus on.
When TF1 is glued to -100 and TF2 continues to decline, as explained in previous articles, TF1 reaching -100 does not necessarily indicate a bottom. When TF2 is also falling as in this case, a strong downtrend may continue.
Furthermore, on both the daily and 4-hour charts, the Histogram DX and DX2 are all red, and ADX_DX is lit.
In particular, since all-direction alignment signals are also confirmed on the 4-hour chart, the conditions for downward direction on higher timeframes are very well aligned.
In such a market, following the direction of the higher timeframe and aiming for a short entry on a line-touch on the 15-minute chart is a simple and good approach. Of course, if other entry triggers are available, you may use those as well.
If using Prime Combo Signal + DSATEA (one example of usage)
First set to “Short Only” and apply Prime Combo Signal to the 15-minute chart. Since both the daily and 4-hour charts have ADX_DX lit, you can use this as a filter.
If it were me, I would consider a combination of “Short Only” + “Line-Touch” + “ADX_DX filter on the 4-hour and daily charts” + “Each condition set to [Moment]”
as one candidate.
Confirm the downward bias on the daily and 4-hour charts, and target the timing of a pullback sell on the 15-minute line-touch, a relatively simple setup. However, with the [Moment] setting, signals may fluctuate or disappear, so be aware. When using the [Moment] setting, ensure proper environmental recognition as a prerequisite.
Of course, this is only one example of a setting. The results will change with different filter combinations and settings, so please conduct backtests and find settings that fit you.
I hope this is at least somewhat useful to everyone.
Clicking the GOOD mark would give me motivation for the future. I would appreciate your continued support as well.
